You should probably clear the CMOS just to be sure there are no leftover settings from the BIOS you upgraded from. I'd test it with the new kit and if it does the same thing I'd suspect the MB is the problem. RAM Configurator-G.SKILL International Enterprise Co., Ltd.īut it might be faulty or possibly there is an issue with the MB RAM slots or the CPU's IMC (cooler too tight ?) That kit (F4-3200C16D-32GTZRX) is listed by G.Skill as compatible with your MB and CPU: And this would be a good time to try a different PSU too. When I pull a board to verify there are no extra standoffs or foreign objects, if I find nothing amiss, I will typically then assemble everything outside the case on a large wooden cutting board to make sure it works there - or not. Look for other foreign objects too, like a wayward screw. So, you might want to pull the board and verify you only inserted a standoff where there is a corresponding motherboard mounting hole. The results range from "nothing" happening (everything works perfectly) to odd "intermittent” problems to "nothing" (as in nothing works at all ). Any extra standoff creates the potential for an electrical “short” in one or more circuits. Note motherboard typically require at least two connections and many graphics cards require additional power connections too.ĭid you double and triple check your stand-offs? A common mistake by the less experienced and distracted pros alike is to insert one or more extra standoffs in the case under the motherboard. So you don't have to buy QVL listed RAM but you should buy RAM with the same specs as listed RAM.Ĭheck your wiring to ensure all required power connections are connected and secure. Note there are way too many RAM makers and models for motherboard makers to test and list them all. I hope to make it in time for the release of Cyberpunk 2077 tomorrow! I will keep you updated on the situation. If anyone has experienced this problem, or has any suggestions, please post. I will receive them tomorrow and see if it works. I checked the QVL list on the main site ( QVL ) and the RAM`s I have are not listed (b550+ryzen 5000), so I ordered another model that was in the list (F4-3200C16D-16GTZR ). I also tried taking out the GPU, but nothing changed. I tried swapping the rams, installing just one or the other, and same problem. ![]() The motherboard is stuck on Error code 00 (which is in the manual) and the Q-led of DRAM is lit. When I push the start button, all the parts start, light up, fans work, but nothing shows up on the monitor (which I am using now on my old build). I followed the exact steps from this link ( BIOS flash ). In preparation for the build, I have flashed the BIOS using the latest software from the site. ![]() I just finished building my new PC and it does not boot.
0 Comments
Leave a Reply. |